Converting Magnepan MG10QR's to DSP crossover

[HAL]

Rewiring the MG10QR's for biamping. Wire harnesses are installed.

Next is removing the original connectors and install th4 5-way binding posts.

Attachments

[HAL]

The MG10QR's connector plate with the new biamp wiring and 5-way binding posts is ready to install on to the speaker.

Now to shrink tube the original connector wiring and then on to speaker #2.

Attachments

[HAL]

First MG10QR rewiring for biamp use is complete!

Time to rework speaker #2.

Attachments

[tomp]

Nicely done. Looking forward to the results.

[HAL]

tomp,
Thanks!

Once #2 is modified, will make some frequency response measurements with REW and dspNexus 2x8 to see what needs to be done to get a good response from them.

[HAL]

The second MG10QR is now modified for biamp wiring. A lot easier the second time through!

Attachments

[HAL]

Second half of the installation.

Now time to connect the dspNexus 2x8 for some driver level measurements.

Attachments

[HAL]

Made the 2ft speaker cables for the MG10/QR with the biamp wiring.

Time to setup the speakers and make frequency response measurements for the DSP crossover design.

Attachments

[SoundMods]

After all that work please do not keep those cheap-ass fuses. Here is a link for some nice sand-filled fuses that enable the best possible sound quality.

https://www.ebay.com/itm/154043810677?h ... R-qO09SpYg

[HAL]

After all that work please do not keep those cheap-ass fuses. Here is a link for some nice sand-filled fuses that enable the best possible sound quality.

https://www.ebay.com/itm/154043810677?h ... R-qO09SpYg

Thanks! Will give them a try.