| DCAudioDIY.com http://www.dcaudiodiy.com/phpBB3/ |
|
| Need low compliance carts and bodies http://www.dcaudiodiy.com/phpBB3/viewtopic.php?f=7&t=680 |
Page 1 of 1 |
| Author: | J-ROB [ July 26th, 2016, 6:01 pm ] |
| Post subject: | Need low compliance carts and bodies |
Looking for a couple old low compliance carts or bodies that I can put aftermarket conical styli in. I can use older Stanton 6xx, Shure bodies (M44, M3, M7 etc), Pickering XV-15, and so on. Already have Stanton 500 in stock. I'm messing with a few Rek o Kut and Lencos with fixed position cartridge mounts and arms that you could use as deadly weapons, so conical at 3g+ is the way I need to roll! Let me know Joe |
|
| Author: | randy warren [ July 27th, 2016, 11:14 am ] |
| Post subject: | Re: Need low compliance carts and bodies |
J-ROB wrote: Looking for a couple old low compliance carts or bodies that I can put aftermarket conical styli in. I can use older Stanton 6xx, Shure bodies (M44, M3, M7 etc), Pickering XV-15, and so on. Already have Stanton 500 in stock. I'm messing with a few Rek o Kut and Lencos with fixed position cartridge mounts and arms that you could use as deadly weapons, so conical at 3g+ is the way I need to roll! Let me know Joe Joe, I may have some of those kicking around, let me check after my class ends Thursday... |
|
| Author: | Roscoe Primrose [ August 13th, 2016, 10:16 am ] |
| Post subject: | Re: Need low compliance carts and bodies |
If you're still in need of, I have an M44C and a 681EEE.... Roscoe |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|