| DCAudioDIY.com http://www.dcaudiodiy.com/phpBB3/ |
|
| Archival info on tone arm setup http://www.dcaudiodiy.com/phpBB3/viewtopic.php?f=5&t=728 |
Page 1 of 1 |
| Author: | tomp [ October 10th, 2016, 5:19 pm ] | ||
| Post subject: | Archival info on tone arm setup | ||
I was going through some old papers and found a sheet that Mitchell cotter of the Varion step up transformer and Cotter turntable fame sent to Dick Sequerra. Dick sent me a copy many years ago. I scanned it and am including it in case anyone is interested. It may have been supplanted by now but it is interesting to see the hand drawings and charts. Tom
|
|||
| Author: | SoundMods [ October 10th, 2016, 6:48 pm ] |
| Post subject: | Re: Archival info on tone arm setup |
I have Mitch Cotters' transformer. But that was not his only claim to fame. His use of mil-spec cabling -- band-pass filters -- low-noise pre-amps -- mil-spec parts -- turntable isolation -- just to name a few. He was ahead of his time and his designs are valid to this day. |
|
| Author: | tomp [ October 10th, 2016, 7:06 pm ] |
| Post subject: | Re: Archival info on tone arm setup |
I met Mitch several times at Dick's place when he was still in Long Island. Very knowledgeable guy. Tom |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|
