DCAudioDIY.com

OK, who's going to be the first to make this the "Next Big Thing" in audio cables?

https://magneticsmag.com/luvata-pursues-ev-market-to-apply-hollow-magnet-wire-in-direct-cooled-stators/

just what we need. An audio cable that will probably cost $5k/foot

Paul,

I wouldn’t worry about it, the wire is shaped that way for coolant to run thru the center for stator windings in motors. Not sure if audio applications need to worry about cooling conductors, though perhaps transformers and speaker voice coils may benefit, the wire gets pretty small for that to be practical.

David

You are thinking too hard.
I went along with the silliness of the first post and just added my two pennies' worth.
I do not think heat would be an audio issue but the skin effect is

Audio Analysis has been doing this with woven cable for years.

Good catch, Pete.

TubeDriver wrote:Audio Analysis has been doing this with woven cable for years.

good range of prices

Can't vouch for Analysis Plus since I don't own any of their products. But I know that OMA Audio is a dealer and it is the only cable they sell. OMA stuff is not cheap so it is interesting that they use Analysis Plus stuff rather than some esoteric and ultra pricey cable. In fact, I think I'll order up a set of their entry speaker cables to see how they sound.

Perhaps I should use this for my amplifiers and speaker wires. Just spray on some insulation.

https://www.homedepot.ca/product/cerro-copper-pipe-type-l-1-2-inch-x-12-foot-straight-length/1000124164

ray