DCAudioDIY.com http://www.dcaudiodiy.com/phpBB3/ |
|
My cheap speaker project http://www.dcaudiodiy.com/phpBB3/viewtopic.php?f=4&t=2179 |
Page 4 of 4 |
Author: | mix4fix [ October 10th, 2022, 8:34 pm ] |
Post subject: | Re: My cheap speaker project |
brombo wrote: A drawing and dimensions please. 3 inch by 3 3/4 inch. I don't have any extra loose binding posts. My plan was to use nuts-n-bolts on the plastic, but it may not go as I was planning. brombo wrote: Here is how I did my speaker terminals. I can help if you want. I used a small milling machine to drill the holes for the banana jacks accurately - Attachment: SpeakerTerminals.jpg I live in Silver Spring. I like what you did. I will figure out a time to come up. |
Author: | brombo [ October 10th, 2022, 9:01 pm ] |
Post subject: | Re: My cheap speaker project |
I have a lot of spare dual binding post and dual banana jacks if you want any. |
Author: | mix4fix [ October 10th, 2022, 10:49 pm ] |
Post subject: | Re: My cheap speaker project |
What will frequency will a 470 mF capacitor do? |
Author: | tomp [ October 11th, 2022, 6:50 am ] |
Post subject: | Re: My cheap speaker project |
Here is a link to a web site where you can put in the impedances of the drivers and the desired crossover frequency and it will give you the values need for the crossover. https://www.v-cap.com/speaker-crossover ... Calculator |
Author: | pboser [ October 11th, 2022, 7:03 am ] |
Post subject: | Re: My cheap speaker project |
With a 6 ohm tweeter a 470uF cap will give a crossover at about 56 Hz. In other words WAYYYY too big a cap. |
Author: | mix4fix [ October 11th, 2022, 12:34 pm ] |
Post subject: | Re: My cheap speaker project |
I think it is mF, not uF. |
Author: | brombo [ October 11th, 2022, 1:19 pm ] |
Post subject: | Re: My cheap speaker project |
mF would be milli-farads which would be enormous. |
Author: | mix4fix [ October 12th, 2022, 9:03 pm ] |
Post subject: | Re: My cheap speaker project |
tomp wrote: Here is a link to a web site where you can put in the impedances of the drivers and the desired crossover frequency and it will give you the values need for the crossover. https://www.v-cap.com/speaker-crossover ... Calculator Is there a reverse calculator that will give you a frequency of a certain component? |
Author: | brombo [ October 12th, 2022, 9:50 pm ] |
Post subject: | Re: My cheap speaker project |
Check these out - https://windowsreport.com/best-crossove ... -software/ |
Author: | mix4fix [ November 1st, 2022, 3:54 pm ] |
Post subject: | Re: My cheap speaker project |
brombo wrote: I have a lot of spare dual binding post and dual banana jacks if you want any. I will schedule something, possibly next week. |
Page 4 of 4 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |